LaserLine Direct Reading Laser Version Grade Cut/Fill Rod 10 foot

Direct Reading, Cut/Fill Rod (also known as Lenker style) is a Grade Rod with a moveable tape face
allowing you to set the actual benchmark elevation, or any elevation, above or below the bench into the
rod. The actual true elevation above sea level is read on these rods, thus eliminating errors caused by adding
or subtracting. Since no math is involved, grade shots are much faster than conventional style rods.
On most jobsites, the bench elevation is typically established by survey, and all elevations on that project are
above that or below primary bench elevation.

EXAMPLE:
In the USA, these elevations are typically represented in feet, tenths and hundredths of a foot as per the example.
Read on rod as
Bench Elevation: 2352.50 2.50
Bldg. A Footing Elevation: 2351.50 1.50
Bldg. B Finish Floor Elevation: 2353.85 3.85
Catch Basin #12: 2349.28 9.28

Laser or optical. These grade rods are the number one seller in the USA, and there’s a reason — Tremendous Quality. Tough, lightweight, and versatile, our direct reading (lenker style) rods bear the true test of quality in the field, and hold up exceptionally well. Choose from our large selection of lengths and increments in tenths, metric, and inches.
Laser Version Direct Reading/
True Elevation Rods For use with a laser detector. There is a special rail slide and Laserline detector bracket that lets the laser detector travel the full working length of the rod. This allows faster and easier readings because it takes the awkwardness out of having to loosen the detector, move the detector, then tighten the detector for each reading.

UB-1 Universal Bracket: Works with virtually all receivers

4-Foot Rod Extension: Allows you to extend the GR1000 Series Direct Reading Grade Rods in 1-foot increments up to 4 additional feet. (Please Note; The 4 foot extension is NOT compatible with GR10, GR15 or GR1450 series rods)

Aluminum front and rear rods.
Made of high strength clear anodized aluminum for lightweight, rugged, dependable operation. They will not rust, split, splinter, swell or warp in any environment.
Tape has heavy duty matte textured face.
Easy on the eyes in bright sunlight. Protects the tape numbers from wear and fading.
Tape lock grommets are oversized,
heavy duty brass. Greatly minimizes the problem of tape tearing.
Detector rail is black, high density, U.V. stabilized for long life.
Specifically designed to not become brittle when exposed to ultraviolet rays or direct sunlight.
Solid tape lock with internal brake slide.
Stronger, trouble-free operation.
Tape lock pin cannot puncture tape.
Designed not to tear, puncture or rip tape when pushed against tape face instead of the grommet hole.
DuPont nylon parts.
Tough and rugged for long-lasting life. Same material used for ski bindings and motorcycle parts